Cms not recognized after plugging in warthog usb

Post Reply
JACK_COLWILL
Posts: 6
Joined: Mon Aug 06, 2018 9:15 am
Product: R3L
S/N: 79

Cms not recognized after plugging in warthog usb

Post by JACK_COLWILL »

I am using the FSSB R3 with the thrustmaster board. Recently I updated my target software because I bought the TM TPRpedals. But now RS HID Device tool doesn’t recognize the buttons properly. For example, normally I use the CMS Centre to start the SMM menu. Now I press the CMS centre button and it doesn’t do anything. IF I press the RIGHT TRIM is starts the SMM Menu. All buttons are not being recognized properly. I press CMS Right and the HID Device software show it as being TMS RIGHT. The TMS RIGHT is being recognized as the PADDLE BUTTON. I tried uninstalling everything and reinstalling and that didn’t help. Now if I unplug both cables, start the RD HIDdevice tool, then plug in the RS R3 cable, the hid device tool recognizes all the keys properly. If I plug the TMwarthog USB cable, then all the buttons are not recognized properly.ive tried uninstalling everything and reinstalling and still no luck. Anyone ever have this?


Ok, I installed the RS software on my other computer which doesn't have any TM target software on it. In fact this is the first time I ever plugged the TM in that computer. Then I installed the RS software, plugged the RS usb cable in and works fine. Then I plug the TM usb cable in and same problem. So it shouldn't have anything to do with me updating the target software on my computer. That must have been coincidence.
JACK_COLWILL
Posts: 6
Joined: Mon Aug 06, 2018 9:15 am
Product: R3L
S/N: 79

Re: Cms not recognized after plugging in warthog usb

Post by JACK_COLWILL »

after about 6 hours of troubleshooting this I finally figured out the problem was. The TM stick firmware got updated to V12. I put it back to V11 and all is good.
fuzzysham
Posts: 3
Joined: Wed Mar 27, 2013 10:04 pm
Product: R3
S/N: 12

Re: Cms not recognized after plugging in warthog usb

Post by fuzzysham »

I'm having the same issue and it is driving me nuts. Do you know where I can locate the older firmware?
Dragon
Posts: 702
Joined: Thu Jan 10, 2013 6:03 pm
Product: ---
S/N: 0

Re: Cms not recognized after plugging in warthog usb

Post by Dragon »

As soon as we have a few time free, we will see what is new in the new TM firmware, and will try to find a turn around
Virus
Posts: 18
Joined: Fri Dec 28, 2018 2:00 pm
Product: R3L
S/N: 91

Re: Cms not recognized after plugging in warthog usb

Post by Virus »

Hi today i received this wonderful piece of hardware but i have the exact same issue as described above.
I checked and i also have the v12 firmware for the warthog stick.
I cannot downgrade it also because i have a few target scripts with the last target version.
Would be possible to do something for this issue or i won't be able to modify the settings on the fly
Post Reply