Aer_FW problems +
Posted: Mon Dec 18, 2017 9:51 pm
Hi
since I have had the FSSB, nearly two years, I have always used the AER FW. In fact I had much contact with Manuel while it was developed.
It has always worked well.
Now I am using RS Tools V 10_01 and I am having problems with this Aer FW.
I am using DCC 1.05, and Aer_Fw 1_02 (my preferred FW) loads ok but has wrong actions when pressing DMS and TMS buttons.
Without pressing SMM button or paddle, pinky etc, DMS buttons alone are changing Roll Sensitivity, and TMS buttons alone are changing Pitch Sensitivity.....????
Furthermore the pressing of DMS or TMS no longer show as being pressed in the small stick graphic of the device tool.
I will add that I have two warthog sticks and both produce the same results when attached, also the same results happen on both my PCs, one has Win 7 and the other Win 10.
I would like to know if this a new bug in this firmware or if it my FSSB itself.. because I am also experiencing difficulty when plugging the cable into my FSSB, I have to move it around a bit before it comes alive.
It doesn't seem to connect very easily, and is no longer a good fit. Could this be part of the problem for incorrect operation of the buttons?
Should I return my FSSB for maintainance to correct this? Is my unit still under warranty? I purchased in Jan 2016.
I would appreciate your thoughts on this as soon as possible, because for the moment I will have to go back to using a warthog base....
Many thanks
Mick
since I have had the FSSB, nearly two years, I have always used the AER FW. In fact I had much contact with Manuel while it was developed.
It has always worked well.
Now I am using RS Tools V 10_01 and I am having problems with this Aer FW.
I am using DCC 1.05, and Aer_Fw 1_02 (my preferred FW) loads ok but has wrong actions when pressing DMS and TMS buttons.
Without pressing SMM button or paddle, pinky etc, DMS buttons alone are changing Roll Sensitivity, and TMS buttons alone are changing Pitch Sensitivity.....????
Furthermore the pressing of DMS or TMS no longer show as being pressed in the small stick graphic of the device tool.
I will add that I have two warthog sticks and both produce the same results when attached, also the same results happen on both my PCs, one has Win 7 and the other Win 10.
I would like to know if this a new bug in this firmware or if it my FSSB itself.. because I am also experiencing difficulty when plugging the cable into my FSSB, I have to move it around a bit before it comes alive.
It doesn't seem to connect very easily, and is no longer a good fit. Could this be part of the problem for incorrect operation of the buttons?
Should I return my FSSB for maintainance to correct this? Is my unit still under warranty? I purchased in Jan 2016.
I would appreciate your thoughts on this as soon as possible, because for the moment I will have to go back to using a warthog base....
Many thanks
Mick