Real Simulator FSSB Forum

I'm having a problem after I reinstalled TUSBA R2 under Win10 with the latest software and firmware. I need to recalibrate the throttle axis (because I can't reach the full afterburner position in BMS), however the calibration section is not available. It seems that Win10 recognizes the devices but is unable to show both the test and the calibration pages.

Here you can see the Property page with the calibration section grayed out.

Hi Francesco,

Please, download the pdf file and follow the instructions to fix the problem. It is a w10 bug with composite devices.

http://www.realsimulator.com/download/W ... roblem.pdf

Best regards


Shark

I have the same problem. My FSSB R3 and Tusba R2 are visible in windows10 but no calibration data is visible.
I can not download the pdf file mentioned in this post.
Please make it possible.
Thanx/

Hi Peter,

You can find the info in the User Guides in the FAQ section under the "My device has suddenly stopped working after connecting it or turning on the computer" explanation.

Best regards,

Hi there,
I am having problems with my Tusba R2 two, basically, windows 10 detected a different device depending of a magic random parameter and lost any previous configuration. Also with the cursor in the neutral position, the values (cursor X,Y) are offset (instead of 0,0 I am having 5,3 etc). I can fixed it momentarily by disconnecting the device and connecting it again.

Carlos,
I sent you a private message.
Regards,