Page 1 of 1
Trim as 4 way only?
Posted: Tue Aug 04, 2020 7:06 pm
by Caboose
Is there a way to make the trim hat ONLY function as a 4 way so that it ignores diagonal presses?
Re: Trim as 4 way only?
Posted: Tue Aug 04, 2020 7:59 pm
by Caboose
I've found a workaround for this - set the stick to Trim as POV in the RS software. Then rebind your controls in DCS, clearing out your old trim bindings. It will bind as a POV in game and then will work flawlessly without any diagonal button presses.
This would be mitigated if the trim hat switch were a bit more stiff and harder to accidentally press diagonally.
Re: Trim as 4 way only?
Posted: Wed Oct 07, 2020 7:19 pm
by GK61
Caboose wrote: ↑Tue Aug 04, 2020 7:59 pm
I've found a workaround for this - set the stick to Trim as POV in the RS software. Then rebind your controls in DCS, clearing out your old trim bindings. It will bind as a POV in game and then will work flawlessly without any diagonal button presses.
This would be mitigated if the trim hat switch were a bit more stiff and harder to accidentally press diagonally.
Good info and concur on the sloppy HAT switch, I only wish that Delta Sim Electronics (
https://deltasimelectronics.com/) would help us out on this.
Re: Trim as 4 way only?
Posted: Thu Oct 08, 2020 6:12 pm
by Supmua
GK61 wrote: ↑Wed Oct 07, 2020 7:19 pm
Caboose wrote: ↑Tue Aug 04, 2020 7:59 pm
I've found a workaround for this - set the stick to Trim as POV in the RS software. Then rebind your controls in DCS, clearing out your old trim bindings. It will bind as a POV in game and then will work flawlessly without any diagonal button presses.
This would be mitigated if the trim hat switch were a bit more stiff and harder to accidentally press diagonally.
Good info and concur on the sloppy HAT switch, I only wish that Delta Sim Electronics (
https://deltasimelectronics.com/) would help us out on this.
Completely different types of switches and purposes. Deltasim uses axis input switch (similar to Xbox analog directional pads) rather than DX button inputs. It is fine for slewing around but doesn’t really work well with the Hornet in real slew mode where you have to press/hold the center then slew.
Re: Trim as 4 way only?
Posted: Tue Mar 09, 2021 10:10 am
by Dragon
Thanks for your patience, we will comeback to this feature in the next software.
We are finishing the incoming throttle as far as finished the feature will be implemented.