Page 1 of 1

Sticking trigger

Posted: Sat Dec 26, 2020 8:01 pm
by BuzzBomb
when I received my F16SGRH (not a CE) in October the trigger was a little sticky. I figured it may be a little "tight' and just needed to break in a bit. Fast forward to December and now it has so much friction that it will often stick in the first stage after releasing from a full trigger pull. i have to then grab the trigger and pull it out in order for it to 'snap' back to its fully extended position

Its essentially unusable in this state

Any ideas or suggestions?

Re: Sticking trigger

Posted: Mon Dec 28, 2020 8:28 am
by Dragon
Hi. your trigger in the F16SGRH must be soft, only the F18 version have the heavy first detent. So if your trigger its hard to move or something stranger have enter inside (very rare) or the M3 screw its to tight.

If your 3M screw its not tight, I really can not imagine just as its a very simple system.

Please send me an email to and I will try to help you in the best way.

Re: Sticking trigger

Posted: Sat Mar 20, 2021 5:36 pm
by BuzzBomb
I’m sorry I didn’t get back to you, notifications apparently were going to the wrong email. I solved the issue by lightly sanding the “guide” in the trigger housing.