Real Simulator FSSB Forum

Hi there, hoping to reach @Dragon or @Shark...

WEBSITE NOW WORKING IGNORE: FYI, the RealSimulator website is replying with the following (using a normal browser, private session and then vpn and private session to another country):
so I have headed over to the forums.

After taking some time off flying to do more racing sims, I am reasembling my flight hardware, including my FSSB R3, FSSB R3 lightening and TUSBA R2 which have been packed away and stored safely. All was going well until I plugged in the FSSB R3. Not a sausage. No chirp. No USB plugged in dingle from the OS. Nada.

Here is what I have checked so far:

• Checked the device manager
• Plugged directly into PC
• Switched to cable from other working FSSB R3 Lightening
• Repeated the above on another computer

None of these made any difference - none registered the FSSB with the computer.

However, having swapped in my F18CGH to the base, the initialisation leds on the grip lit up - so some power is getting through.

My guess is the usb controller has died, but I guess as per suggestions in other threads that the board/processor could have a problem. Hopefully not!

Look forward to hearing back!
Cheers
Chris

Unfortunately for what I read in your post, the USB inside the microprocesor is damaged.
Please send an email to general_inf@realsimulator.com and tomorrow we will talk about send back the unit for repairing

Cheers.

Thanks @Dragon, will do