Real Simulator FSSB Forum

Hi all,

I have some z axis movement in my stick. It's not a lot of movement, but maybe 10-15 degrees. Anyone have any experience with this? Is there any adjustment screws on the stick to solve this? I have tried to thighten the small screws on the stick but that does not help.

I have to constantly thighten the connection, which is pretty annoying and breaks the immersion.

In advanced, thanks.

Willdass

Dear.

Where is the Z movement?
a- between the aluminium white rod and the F16SGRH
b- between the Black aluminium rod and the R3
c- between the black aluminium R3 rod and the white aluminium F16SGRH rod.

If is the c, I can help you with a small sand paper cut as a circle to help you to increase the friction, normally aluminium with aluminium is enough friction, but if you need extra retention for the nut, the sand paper can help. PLease send a message to general_inf@realsimulator.com

Thanks