Hello evreybody,
today i´ve build a new simulator.
i´ve put my fssb r3 in it as usual.
suddenly the y axis was a little bit off so i´ve tried to center the stick via Special Modes Trigger1 switch.
the centering only worked for the x axis while leaving the y axis unattended.
after a few attemts of calibrating in windows my y axis isn´t working at all.
on windows calibrating tool the y coordinates always stay at 65535.
any help is appreciated.
kind regards patrick
y-axis not responding
-
- Posts: 4
- Joined: Thu Dec 26, 2013 12:24 pm
- Product: R3
- S/N: 32
- Location: Duesseldorf Germany
-
- Posts: 702
- Joined: Thu Jan 10, 2013 6:03 pm
- Product: ---
- S/N: 0
Re: y-axis not responding
Hi Patrick
I am waiting your R3, as soon as I got it, I will keep you updated
Manuel
I am waiting your R3, as soon as I got it, I will keep you updated
Manuel
-
- Posts: 702
- Joined: Thu Jan 10, 2013 6:03 pm
- Product: ---
- S/N: 0
Re: y-axis not responding
Received
Testing and hope tomorrow send back to you
Best Regards
Manuel
Testing and hope tomorrow send back to you
Best Regards
Manuel
-
- Posts: 702
- Joined: Thu Jan 10, 2013 6:03 pm
- Product: ---
- S/N: 0
Re: y-axis not responding
Dear Patrick.
The R3 has been tested, and we have found metallic particles inside the R3, unfortunately the electronic board has been contaminated with some thin aluminium wires and also unfortunately this metallic contamination has ruin the electronic board.
We have proceeded to change the complete sensor and electronic unit and yesterday norming was shipped to your address, so you must have it at your home today or tomorrow.
Hope you enjoy your R3 and wait your news.
Best Regards
Manuel
The R3 has been tested, and we have found metallic particles inside the R3, unfortunately the electronic board has been contaminated with some thin aluminium wires and also unfortunately this metallic contamination has ruin the electronic board.
We have proceeded to change the complete sensor and electronic unit and yesterday norming was shipped to your address, so you must have it at your home today or tomorrow.
Hope you enjoy your R3 and wait your news.
Best Regards
Manuel
-
- Posts: 4
- Joined: Thu Dec 26, 2013 12:24 pm
- Product: R3
- S/N: 32
- Location: Duesseldorf Germany
Re: y-axis not responding
I've been on a job for about a month now and returned today.
You did a great job by repairing my device and returning it in just 4 days!!!
Awesome job from an awesome Company!
Kind regards ugamanuga
You did a great job by repairing my device and returning it in just 4 days!!!
Awesome job from an awesome Company!
Kind regards ugamanuga