Hello,
I am having difficult understanding the HID tool.. At times it will lock up, and when it doesn't it does not appear that I can do anything with it; change and edit values etc. It also indicates "firmware not supported" but I am using all the latest firmwares.
Is there something wrong with the current version of HID with Wins 8.1? Am I am able to remove or start fresh with a firmware for either of the FCCB RS3/TUSBA, or RUSBA?
Jody
HID Issues
-
- Posts: 137
- Joined: Thu Jan 10, 2013 1:44 pm
- Product: ---
- S/N: 0
Re: HID Issues
Dear Jody,
Please, install the latest firmware and software and check if the problems continue. If the RS_HID_DEV_TOOL says "Firmware non supported" you must not to have installed the last version.
If you continue with the problem, report the versions installed to test us here.
Best regards,
Bart
Please, install the latest firmware and software and check if the problems continue. If the RS_HID_DEV_TOOL says "Firmware non supported" you must not to have installed the last version.
If you continue with the problem, report the versions installed to test us here.
Best regards,
Bart
-
- Posts: 8
- Joined: Fri Jan 23, 2015 1:13 pm
- Product: R3
- S/N: 96
Re: HID Issues
Shark,
Yes I just figured this out. Your staff sent me the latest HID and DCC files. You might want to update your forums as they have older files which I have been using.
Thank you!
Jody
Yes I just figured this out. Your staff sent me the latest HID and DCC files. You might want to update your forums as they have older files which I have been using.
Thank you!
Jody