Hello,
Is there any way to increase the sensitivity of the pitch and roll axes beyond using the pre-sets? I seem to recall that there were switches or resistors on the PCB that could be changed to do this.
Max sensitivity
-
Shark
- Posts: 137
- Joined: Thu Jan 10, 2013 1:44 pm
- Product: ---
- S/N: 0
Re: Max sensitivity
Hello Mfrank14,
The FSSB-R3 is shipped with an sensibility adjust of 7,75 lb for roll and 8,50 lb for pitch. You can change this values from 2,5 and 4 lb respectively until 13 lb using the HID_DEV_TOOL utility or using the stick switches thru the special modes.
About the switches and resistorsto change the sensibility, that is the method used in the FSSB-R1 and FSSB-R2.
Regards,
Shark
The FSSB-R3 is shipped with an sensibility adjust of 7,75 lb for roll and 8,50 lb for pitch. You can change this values from 2,5 and 4 lb respectively until 13 lb using the HID_DEV_TOOL utility or using the stick switches thru the special modes.
About the switches and resistorsto change the sensibility, that is the method used in the FSSB-R1 and FSSB-R2.
Regards,
Shark